Data Access Worldwide Knowledge Base
Article Text
QUESTION;
While reading the ideclasses.dfc file I noticed most lines have 3 fields and some have 4. Is this normal?
ANSWER:
Yes, it is quite normal and supported. If you leave a field blank, then a default value will be applied to it.
These columns basically represent the fields in the Studio's "Configure Class Lists" dialog. If you edit one of the entries, you will see what gets written in which position. However, I recommend instead that you use this dialog to edit the file instead of a text editor. The "Workspace" tab page will edit the local workspace "IdeDialogs" and the Global page edits the global file.
Contributed By:
John van Houten
Company: Data Access Worldwide
Web Site: http://www.dataaccess.com
Email this Article
Email this Article to a Colleague
Send Feedback on this Article to Data Access Worldwide
Copyright ©2010 Data Access Corporation. All rights reserved.
| The information provided in the Data Access Technical Knowledge Base is provided "as is" without warranty of any kind. Data Access Corporation disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall Data Access Corporation or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if Data Access Corporation or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply. |