Data Access Worldwide Knowledge Base
Article Text
QUESTION:
Is there a way I can specify command line arguments when debugging my Web Application?
ANSWER:
Yes, it's possible. To specify command line arguments when debugging, select Program -> Properties in the Studio and specify the command line parameters in the Parameters field.
The command line arguments set up in the Administrator are not used when running the program from the Studio.
It may seem confusing at first, but it's no different from a Windows program. i.e. you normally set up command line arguments using a shortcut to a Windows program, but when running from the Studio, the shortcut is obvioulsy not used, and so the command line arguments are not used either. It's exactly the same with a webapp program.
Contributed By:
Sonny Falk
Company: Data Access Worldwide
Web Site: http://www.dataaccess.com
Email this Article
Email this Article to a Colleague
Send Feedback on this Article to Data Access Worldwide
Copyright ©2010 Data Access Corporation. All rights reserved.
| The information provided in the Data Access Technical Knowledge Base is provided "as is" without warranty of any kind. Data Access Corporation disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall Data Access Corporation or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if Data Access Corporation or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply. |