Data Access Worldwide Knowledge Base
Article Text
PROBLEM:
The compiler does not launch from inside the Studio. When I try to compile, some type of message just flashes on the screen and then I am returned to the Studio. I can compile my program by launching the compiler separately.
SOLUTION:
Most likely, somewhere along the paths that the Studio uses to call the compiler, a termlist.cfg is found from another version of Visual DataFlex or DataFlex that interferes with the Studio's calling the compiler. Check for extra copies of termlist.cfg in your VDF installation or workspaces. There should only be one copy of this file, located in the \bin subfolder where VDF is installed.
Email this Article
Email this Article to a Colleague
Send Feedback on this Article to Data Access Worldwide
Copyright ©2010 Data Access Corporation. All rights reserved.
| The information provided in the Data Access Technical Knowledge Base is provided "as is" without warranty of any kind. Data Access Corporation disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall Data Access Corporation or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if Data Access Corporation or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply. |